Per-Sator Modules

SATOR modules with enhanced connectivity and functionality, optimalised for Crestron, or AMX, Loxone etc., or PC. (partially backward compatible with Per-Nardic I/O cards with PER- firmware).

Communication Crestron-ISC modules [modules Per-Sator with PER fw] allows to connect modules any type „in series“, thus it needs only one serial channel RS232/Ethernet in totoal. Communication is very fast (response <750us), and independet of number of modules being connected.
Installer’s sw uses for each Per-Sator module set of 20 control in/out signals (except DMX interface), which leads to simple sw architecture and possibility to swapping modules or expanding peripherals.

Communication Per-NET modules runs on usual RS485 bus with proprietal Per-NET protocol optimised for maximum bus speed and reliability; MAST485 is automatc driver capable to manage up 250 connected Slave modules, including setting, diagnostic, priority addressing, message heap etc. Connection to Host-PC or Crestron processor is made via RS232 or Ethernet.


Crestron-ISC

5 universal serial ports RS232/485 expander DIN module
Per-com2com6

I/O 16in/8out/8analog-out 0-10VDC DIN module
Per-di16ao8

I/O 16in/16out galvanicaly insulated DIN module
Per-diom16

I/O 16out-relay with 16 galvanicaly insulated 16A/230VAC NO-contact closures DIN module
Per-rom16

I/O 8in/8out-relay with 8 galvanicaly insulated 16A/230VAC NO-contact closures DIN module
Per-dirom8

12-chann PWM LED dimmer DIN module
Per-pwm12

I/O temperature and dig. outs 16temp/16out DIN module
Per-tdom16

interface RS232-DMX512 for 350/2500 channels
Per-DMX512

> connection and software handling example <
(support)

Sator_modules_help-thumb


Per-NET

interface RS232-PERnet master bus-driver
PER-MAST485-RS

module 4temp for PERnet
PER-TEMP-SLV

module 1in/2temp/1out for PERnet
PER-PT100-SLV

module digital 4in/4out for PERnet
PER-CNPI4-SLV

terminal module wOLED disp and encoder for PERnet
PER-OPAD-SLV
(discontinued)

> connection and software handling example <
(support)